Colt anaconda question? - what is my 44 colt anaconda worth
My Colt Anaconda .44 Mag recently have stopped firing 6 shots. Shoot 5 and almost always there is a round pin that is not enough to shoot not affected. It is a pen mark, but is very low. What could the problem and how to solve this problem?
Thursday, February 11, 2010
What Is My 44 Colt Anaconda Worth Colt Anaconda Question?
5 comments:
Have you shot SP 44 in it? If so, there is a ring of dust in the rooms. You need to rub a solvent. The ring holds .44 Mag advance so that the board is seated against the cylinder. When the firing pin hits the primer, consumes a large amount of energy to move the tape forward so that the board is mounted on the cylinder. Then there is energy, it is not enough to ignite the primer.
The obvious answer is no longer master the fire until it was fixed. Do armorer, as you can spend many hours and much money in certain areas, and will probably do nothing. Sounds like a problem of the spine, but it could be something else. Took me to a reliable retailer and lay sources completely replace, if necessary, and clean (for it was when the last time the plate, took off the crane and cylinder, etc.) to the dealer a favor. If you know the location of the bottle, the disapproval of the fire, sat a little white on it. Please do not shoot to find out. Could a timing problem caused by some unusual wear on the cylinder. Normally, the spring is always on the back of each round to shoot. Therefore, I have a little bit about it and suggests guess a gunsmith.
Have you shot SP 44 in it? If so, there is a ring of dust in the rooms. You need to rub a solvent. The ring holds .44 Mag advance so that the board is seated against the cylinder. When the firing pin hits the primer, consumes a large amount of energy to move the tape forward so that the board is mounted on the cylinder. Then there is energy, it is not enough to ignite the primer.
This is a colt.
They are condemned very sensitive. Not quite sure what he did for them, but it seems, could certainly be a matter of spring ... Either that, or in the spring to the striker bar doodlebob Transfer) (is weak or blocked for this purpose with the PIN you just tap the top of the spanking hard enough to play around outside.
Take it to a dealer you trust. If all else fails, sell and buy a Ruger Redhawk.
The obvious answer is no longer master the fire until it was fixed. Do armorer, as you can spend many hours and much money in certain areas, and will probably do nothing. Sounds like a problem of the spine, but it could be something else. Took me to a reliable retailer and lay sources completely replace, if necessary, and clean (for it was when the last time the plate, took off the crane and cylinder, etc.) to the dealer a favor. If you know the location of the bottle, the disapproval of the fire, sat a little white on it. Please do not shoot to find out. Could a timing problem caused by some unusual wear on the cylinder. Normally, the spring is always on the back of each round to shoot. Therefore, I have a little bit about it and suggests guess a gunsmith.
Post a Comment